Prev Page Next Page

Report Statement

Formal Definition

A statement that displays a message.

Simplified Syntax

report string;

report string severity severity_level;


The report statement is very much similar to assertion statement. The main difference is that the message is displayed unconditionally. Its main purpose is to help in the debugging process.

The expression specified in the report clause must be of predefined type STRING, and it is a message that will be reported when the assertion violation occurred.

If the severity clause is present, it must specify an expression of predefined type SEVERITY_LEVEL, which determines the severity level of the assertion violation. The SEVERITY_LEVEL type is specified in the STANDARD package and contains following values: NOTE, WARNING, ERROR, and FAILURE. If the severity clause is omitted in a report statement it is implicitly assumed to be NOTE (unlike in an assertion statement, where the default is ERROR).


Example 1

while counter <= 100 loop
  if counter > 50
    then report "the counter is over 50";
  end if;
  . . .
end loop;

Whatever happens inside the loop, if the value of counter is greater than 50 it will be reported by the listed message. The severity clause is omitted here because the selected level is the same as the default one (NOTE).

Important Notes

Prev Page Next Page